rilpoint_mw113

Configuring MTNL 3g in BOSS

(Created page with 'Setting up your System: * Open a terminal, unload the usbserial driver by using the following command from root. "sudo modprobe -r usbserial" * Plug the …')
Line 1: Line 1:
Setting up your System:
Setting up your System:
-
    * Open a terminal, unload the usbserial driver by using the following command from root.     
+
Open a terminal, unload the usbserial driver by using the following command from root.     
-
         "sudo modprobe -r usbserial"
+
         sudo modprobe -r usbserial
-
 
+
-
    *  Plug the modem and type the following command to find the vendor id and product id
+
 +
Plug the modem and type the following command to find the vendor id and product id
         "sudo lsusb"
         "sudo lsusb"
      
      
-
        You will get output like below:
+
You will get output like below:
         Bus 007 Device 003: ID 413c:2003 Dell Computer Corp. Keyboard
         Bus 007 Device 003: ID 413c:2003 Dell Computer Corp. Keyboard
Line 26: Line 25:
-
          Here my modem vendor and product id are 1c9e:6061
+
Here my modem vendor and product id are 1c9e:6061
-
    *  Now load the driver to match your vendor id and product id using the following command:       
+
Now load the driver to match your vendor id and product id using the following command:       
-
         "sudo modprobe usbserial vendor=0x1c9e product=0x6061"   
+
         sudo modprobe usbserial vendor=0x1c9e product=0x6061  
                      
                      
                
                
-
          Here 1c9e and 6061 are my modem vendor id and product id, you have
+
Here 1c9e and 6061 are my modem vendor id and product id, you have to modify both of this
-
          to modify both of this
+
-
    *    Type the following command to check the driver is loaded or not   
+
Type the following command to check the driver is loaded or not   
-
           "sudo dmesg | grep -i "ttyUSB" "
+
           sudo dmesg | grep -i "ttyUSB"
-
            You will get output like below if driver is loaded.
+
You will get output like below if driver is loaded.
        
        
             [431402.212231] usb 4-2: generic converter now attached to ttyUSB0
             [431402.212231] usb 4-2: generic converter now attached to ttyUSB0
             [431402.214118] usb 4-2: generic converter now attached to ttyUSB1
             [431402.214118] usb 4-2: generic converter now attached to ttyUSB1
             [431402.216118] usb 4-2: generic converter now attached to ttyUSB2
             [431402.216118] usb 4-2: generic converter now attached to ttyUSB2

Revision as of 12:11, 16 March 2011